Running on a single 9V battery, and using a built in sensor, Protectrix™
detects when the garage door is open
When the garage door is open for too long (variable 5 to 45 minutes in 5 minute increments), Protectrix™ sets off a Beep and a flash.
If the garage door is not closed before the alarm ends (30 seconds), Protectrix™ sends a signal to your garage door opener to close the garage (the signal sent is the same as the signal sent from your garage door remote control)
Features:
Can be easily disabled by turning the delay time to 0 minutes.
Works with all existing sensors in your garage, such as the beam and motor force sensors built into most garage door openers.
Alarm beeps and flashes once every minute when battery is low.
Setup:
Installing Protectrix™ is easier than sticking a picture to a wall!
Programming Protectrix™ is just like programming a new garage door remote.
Garage door requirements for Protectrix™:
Your garage door must be parallel to the ground when it is open (almost all garage doors do this); it cannot open straight up or roll up when opening.
You must have an installed electric garage door opener.
Protectrix™ must stick to the upper part of the inside of your garage door.
No wiring, tools or extra hardware is necessary to setup and install.
System Information
Time until Garage
Alarm Goes off:
5 to 45 minutes (5 minute increments)
Alarm:
Prior to close: Audible beep and Flash every second for 30 seconds
Battery Low: Single Audible Beep and Flash every 90 seconds
Battery Type:
9V/9Volt alkaline battery
Battery Life:
2 years: depends on temperature, humidity, and how often Protectrix closes your garage door
Product Warranty:
2 month refund, 2 year replacement
Dimensions:
85mm (3 1/3") x 120mm (4 3/4") x 32mm (1 1/4")200g (7 oz)